🔧 Enhance Your Oster Blender's Performance with the Oster Blender Replacement Parts Refresh O Ring Kit Review

You have an old Oster blender with a large glass lid. The old knife block has started to leak around the drive shaft in the knife module. This exchange went immediately with a new seal and works perfectly. I reused the old screw cap as the new one is not compatible with my blender's skirt.

Pros: The new blade does the job perfectly and the two rings are much more expensive than what the sellers are offering. Cons: The base looks like a fake of the original. It looks different, it's missing some minor design elements, and it's only slightly smaller than the original so it can move around when you turn it on. Not sure how you wear out the base, so not sure why it's even on. I would buy again and again for the parts I need.

I have had an Oster blender for many years! And I mean years and years and years! It still worked fine but every once in a while my cocktail would drip from the bottom. I usually just took it apart and cleaned it, but one day I realized that I'll probably have to buy a new gasket. I was surprised to find out the parts are still in stock. I ended up with two spacers, a new blade and a new floor. Now I feel like I have a new blender! Works very well and does not drip!

Extremely difficult to assemble on the base of the original Easter glass jar, you can almost feel the cross carving. I hope the plastic doesn't eventually crack from interference deformation. In addition, the blades are not curved like the original, hardly touch the glass base even after assembly, and are difficult to reassemble. The diameter of the supplied rubber pad is also slightly smaller than the original and can hardly touch the edge of the glass floor completely. All of the pieces…