🚐 BlueFire Super Bright LED RV Porch Light with ON/OFF Switch, Clear/Amber Lens - Exterior Utility Light 12V Replacement for RVs, Trailers, Campers (1 Pack) Review

This is a great light. Very bright and easy to install. I had one broken. Customer service was great, they sent me a new one the next day. I highly recommend these lights.

delivery exceeded all expectations. Very well and safely packaged. The light (natural white) is bright but not dazzling. I replaced the old 12 volt fluorescent lights in our van with theses and we are very glad we did. Perfect for our camper. Highly recommended.

Very happy with the light output. Super bright and easy to install. We have been using it for a few weeks and have survived several days of heavy rain without any problems. I would say that there are several ways to use this lamp in vans.

The light is bright and almost an exact replacement for my old melted incandescent bulb. My only complaint is that the mounting screws are too small, they really should be a size 2. All in all a good replacement, we'll see how it works. I would recommend a small tube of silicone when purchasing to seal after installation.

Replaced my factory installed LED lights under the awning with this light. It's brighter than the 16-foot LED lights that fell off my RV. I used existing wiring and taped it to the side panel of the RV above the door opening. Yellow light reduces brightness and hopefully repels insects. I take 2 more for front and rear.

Very thin border, not to be glued with butyl tape. Mounting holes do not match the old ones, like nobody builds a new camper, only fixes it! The screws are smaller so the old strong ones can't be used and won't fit in the plastic and the screw heads are so cheap they can be easily removed. I installed it but required a lot of jigs and more tools.

I installed this light on our mobile home. It's brighter than the standard light it replaced. The switch is very handy and the orange lens helps slow down insects. The extra lens is worth the price of the flashlight! I installed the light with the new mounting holes slightly offset from the old holes as they were too big. I was able to screw the new fasteners into the fiberglass without drilling a pilot hole as they have very sharp ends. However, I suggest drilling a 1/16" or 1.5mm pilot hole…

Size is very close to the original 'light' on our mid 80's 17ft RV that we refurbished. It was an easy install, just cut the wires and use the screw nuts provided to connect the new wires. The original didn't have an on/off switch on the outside, so that's a handy bonus. We took it on a hike and it lit up the area around the door well. We had a 12V supply and it worked great. I don't know how different the brightness is from the incandescent version because it didn't work, but it's quite…