🔴 BRISHINE Super Bright LED Bulbs: Brilliant Red 1157 2057 2357 7528 BAY15D - Non-polarity, 24-SMD Chipsets with Projector - Pack of 2 Review

This has been used to convert a 1982 Jeep Scrambler to LED lights. Really bright and just as easy to install as the original bulb. Not on older cars please, you will probably need an LED turn signal for the turn signal to work when the daytime running lights are on. Would buy again!

This is my second review to recognize a supplier for replacing a failed lamp unit very quickly. Overall I'm very happy with the brightness and the LED placement of the focused lens and lamp housing. They use a tail light reflector and work very well as a rain light for my race car.

I wish it would work. I wanted to replace my 1157 tail light bulbs on my 2019 Street Glide Special. The small ridges are in the right place, but the top base feels a bit short. You cannot rotate and lock them. I really want them to work - I have to go back.

I bought these LEDs to replace the taillights in my car. Unfortunately, the performance in terms of brightness is about the same as halogen bulbs, but the overall look of the bulbs is much cleaner than halogen bulbs and they look good in the case. They'll probably last longer than halogens.

Some reviewers have reported issues with bulbs not fitting or working. These lamps were installed in a 5x10 cargo trailer in place of incandescent lamps. The lamps fit into the holder without any problems and work perfectly - no reverse polarity or other problems. Just plug in and go Other reviewers have noted issues with the lamp's short lifespan. You have no experience with lamps. The trailer is rarely used.

Bought it for around $25-30 and it came with four LED bulbs which is a really good deal. I replaced my brake lights and when I compare them to my old bulb they look about the same but I notice that the brake lights come on faster. It fits perfectly into the socket and there wasn't much hassle. I love these lamps and have been using them for several months since the original installation.

I installed these on my 1968 Oldsmobile Cutlass S. They really brought my brake lights, turn signals and tail lights to life. i have red color The 4 piece set was perfect because my car has 4 taillights (two on each side). I took out the old lightbulbs, put these in and that was it. I didn't have to add any wiring resistance or change the turn signal since I didn't change the front bulbs. Hope they have a long life. Very happy with my purchase of these.

These lights may look a little garish in the photo but they are actually perfect. They made my old dim tail/brake lights look like modern cars. Everything worked great, I only used them as a replacement for my old 1157 bulbs. By leaving the front bulbs in place I didn't have to change the turn signal. As mentioned, if you're using them for taillights make sure you have red LEDs.