Enhanced PowerGrip Threaded Locking by Camco 55537 Review

Short term plug with heat gun makes installation very easy. I heated the sleeve on the peg for less than 30 seconds (heating around the peg to soften the entire cuff) and then just slid the Camco retaining ring onto the cuff with no issues. I did not heat the snap ring or put any lubricant on any of the parts. FYI, the 30 amp cord is a Furrion branded power cord.

Expensive but works like the original. I don't usually write reviews but thought I might help others with this 30 amp install tip. I used a heat gun (a hair dryer might work) on low heat to heat the outer raised portion of the fork that attaches to the camper. Be careful not to overheat or melt the rubber stoppers. This softens the raised outer rubber tab so that the ring can be slid on without having to heat the PowerGrip ring. When the rubber on the stopper cools, it becomes as stiff as…

The retaining ring on the shore power connector broke and I was pleasantly surprised that I was able to purchase a replacement rather than buying a whole new connector. My only concern is that it comes with no installation instructions and there is a risk of breaking the new ring trying to install it. Here's how I installed it without breaking it: I soaked the ring in hot water first to make it softer and less brittle. During the soak, I smeared the flange on the connector housing that was…