🏍️ High Performance VM22 26mm Carburetor for Mikuni Intake Pipe - Perfect for Pit Dirt Bikes (110cc - 140cc) by Lifan, YX, Zongshen, XR50, CRF70, KLX, BBR, Apollo, Thumpstar, Braaap, Atomic, DHZ, SSR Review

I put this on a 150rpm Viper before installing it, there is an air screw on the bottom of the carb, turn it all the way in then tighten it 1 1/4 turns out and it will purr like a kitten, more Mikuni might say that but 26.00 is definitely wrong

Purchased for Predator 212 engine if you buy a $20 manifold adapter it snaps in easily but the ignition nozzles inside are a different thread than the stock MikuniCarb ignition nozzle, works as described and is similar to mikuni, but this is by no means a true clone of mikuni

Great since I installed it on my bike, it runs and drives flawlessly, now very responsive with a nice deep tone at idle! Just an update, this carb is rubbish, do not buy after about 2-3 weeks of driving, it started dripping from the overflow, this has been a problem since you spend more money and get better quality.

10/10. With these non-branded products, you usually get poorly finished trims if that's the case. This is available. He even has something that rhymes with Shmishmuni! (Great working photo to buy from the pictures) I threw it on my Pitter and it fired and idled the first time. The nozzle is perfect also for 125 with cams and connectors!

Works as it should. Once fitted to the ssr125 it started straight away and ran after a small throttle cable adjustment. I will be doing more testing soon as these are just first impressions. Will also update if it breaks. I had to use some parts from an old carburetor to make it work properly, like the throttle cable gasket and cover, but other than that it was a straight bolt.

Well I bought this for a 2005 SSR125 F2 BBR Aluminum PERIMETER frame clone. It's a close copy, BUT. Main jet, pilot without number stamp, needle and seat not secured with micro holder and screw, no marking needle, only 3 positions, cheaper version on needle holder, . Throughout the analysis - I will be using the important parts from this carb knock, rebuild the original Mikuni with - restrictor/gasket, float bowl gasket, carb cap gasket, all o-rings, ie. lots for parts but I won't run this carb