💡 Brass SP3T Pull Chain Switch with Off-On-On-On Circuit Function, 6/3 Amps at 125/250 VAC Review

Arrived quickly and in excellent condition. The wires had a bit of trouble connecting to each port and I was able to complete the project in one go. Thanks very much!

Great and easy to use, mark your old wires before disconnecting and strip only about 1/4 inch, tin and press in until they run snaps. Gently pull to check the latch.

The switch is physically labeled L, 1, 2, and 3. L is the common or hot wire, and 1, 2, and 3 are for different loads. You can arrange them in any order, but here is the switching order: L -> 1L -> 2L -> 3L -> OFFRepeat. If you wire this thing up like in that silly drawing, you have a "hot" input in hole #2, then the switch will only turn on once every 4 presses/clicks between terminals L and 2. Whoever pulled that needs to be slapped.

Arrived quickly and in excellent condition. The wires had a bit of trouble connecting to each port and I was able to complete the project in one go. Thanks very much!

Beautiful and easy to use, mark your wires from the old before disconnecting and strip only about 1/4 inch, then tin and push in until it snaps into place. Gently pull to check the latch.

The breaker is physically marked L, 1, 2 and 3. L is the common or hot wire, while 1, 2, and 3 represent various loads. You can arrange them in any order, but here is the switching order: L -> 1L -> 2L -> 3L -> OFFRepeat. If you wire this thing up like in that silly drawing, you have a "hot" input in hole #2, then the switch will only turn on once every 4 presses/clicks between terminals L and 2. Whoever pulled that needs to be slapped.