📞 Efficiently Expand Your Telecom Connections with CHANNEL VISION C-0436 4 in / 8 Out RJ45 Telecom Distribution Module Review

Works great in our small OnQ telecom junction box. All of the phone lines in our home are 8-wire, 4-twisted-pair Category 5e Ethernet cables. After adding RJ45 jacks to incoming and all outgoing lines, the RJ45 jacks on this splitter allowed us to easily swap lines to route from phone to router and back. I can also easily configure two custom patch cords to disconnect phone line 1 and phone line 2 for a connected VDSL2 modem with two phone line inputs, or one patch cord to connect both lines to

Bought one of these to distribute a single line cordless phone to other rooms in the house. All telephone jacks are Category 5 wired and run to a structured junction box where each cable has an RJ45 termination. I chose this product because it fits RJ45 end jacks and because it has enough output leads to plug into any room (and a few spares). The device works as expected even though I'm not using the service/security port. It fits snugly in the Wirepath case with snap pins. It has a strong…

Let me start by saying that I took on this project (replaced my old phone cord with Cat6 and then ran all the phone lines from the central hub with patch panel) I had no idea what i was doing. And so it took me a long time to finally figure out that everything was working as it should. I made sure I had the faulty module and was about to order another (or even a competitor's module). But once I blew the dust out of the ports and hooked everything up properly, this device worked exactly as…