🚘 BMW M Color Stripes Decal Sticker Set - 6"x100" for BMW Hood, Front & Rear Bumpers, Side Fenders Review

Good on the good side, easy to apply. Streaked on a bad color and out of color. it will go away in about a month. only get this if you are poor and have a beamer.

I had the same experience. The month looked great, then it started cracking and peeling off. Does not tolerate heat on the hood. It was painful to remove as it broke into small pieces.

It looked great at first, but only for a week or two, and then as others have said, it started cracking and peeling, almost like peeling an onion peel. Now I have to take it all off and clean it, hoping that no traces remain. Do not buy!

Looks good at first glance, but can't stand anything. It's not vinyl, it's a sticker, so it won't match your car's body lines. Lots of bubbles after installation and wrinkles. I tried taking it off this week and it's not coming off like it should. Peel it off and it's going to hurt and take hours and hours to remove. Save time and money, don't buy

This product was great. about 2 months! Put a sticker on the hood of his car. Unfortunately, the edges were starting to lift and peel, so I decided to remove the whole thing. The sticker is almost impossible to remove (even with a product like Goo Gone). The sticker needs to be scratched off, which will damage the paintwork. We strongly advise against this product!

I love this product. The glue used on this product is amazing. This makes the product very easy to apply. In addition (and this is important) the product is very easy to remove if you decide to install it somewhere else. What an extremely practical product. And the last. If you take your time and assemble the product correctly, it will look like the stripes are painted on. I get compliments on my car all the time. I put the strips on the lower rocker panel and they look great!

Full of garbage. Because it's not vinyl, it won't stretch when it's hot. This is not a water decal. So if you wet the surface it won't stick at all. This is nothing but a 6 inch wide decal. Only suitable for a flat laser (which is not in a car or motorcycle on the planet). and once you put it down, that's it. No adjustment, no stretching, no bending, you have 1 shot. Period. This is the perfect strip for your perfectly straight bookshelf or maybe the top of your fridge. But if you buy this for…

It looks good from over 6 feet away, but by no means does it look clean and pretty up close. I used to have vinyl wrap (the roof was gloss black) and that stuff is a lot harder to work with. It's almost a mix of vinyl and sticker. It's not as malleable as vinyl and will wrinkle in places despite the added heat and time. To identify imperfections, look at the underside of the rear bumper and the creases. Even with the addition of heat/post processing and trying different techniques. Still looks…

It's not paper based, that's good. It is plastic based, not vinyl based. It takes a bit more effort to apply than vinyl as it is not flexible and does not breathe. You have to be patient and work on it. It will stretch so if you need to wrap smooth edges it COULD wrap it but it will wrinkle. Bubbles will go away after a few days, but push them out as much as possible. Plastic grains easily tear vertical. Mine is at a 45 degree angle so if you pull it straight up it will hold the grain and you…