Has pros: Excellent chair. Very good ergonomics. It's not hot, it's comfortable. And all this for relatively little money. Got cons: You can feel the carelessness of working with the fabric. A perfectionist with good eyesight hurts the eye. But the main thing is not to spread.

I took 3 chairs, for myself and for male children))). They sit on them a lot, they say they are comfortable. The seat is a bit small for me, I like to climb in with my legs, it’s a bit crowded here and the headrest is not where I would like, apparently because of my small stature (158 cm), I left it on this side, did not attach it back. Well, it's a good chair.

Convenient comfortable chair, made of fabric, for adequate money! There are "problems" with the back, but you need to get used to it. There is no rigid support for the spine due to the initially laid material, this must be understood when choosing. Has some pros: Comfortable, well ventilated due to fabric and perforation Its cons: the back does not recline completely, the angle is ~ 100-120 degrees

Its pros: The most important thing is that the mesh fabric is perfectly ventilated during long work at the computer, and this is a HUGE plus for comfort! Its cons: If you STRONGLY loosen the seat tilt stiffness screw, then it leans forward and the person moves out.

Got pros: The chair is comfortable, for a height of 174 a headrest around the neck, if you move out a little - a headrest under your head is also normal. Its cons: One bolt turned out to be a defective thread. There are no spares.

Pros: Comfortable, soft. The back does not sweat and nothing slips :) Cons below: It is hard to lean back, sometimes you want to lean on it, but this is done with difficulty

By the way, I didn’t have a cap on the gas lift, which was often written about in the comments. Which is good, but I racked my brain for a long time, trying to understand whether something needs to be removed from the gas lift or not 😁