Complete 32.8ft LED Light Strip Connectors Kit: Extension Cable, Corner & T Shape 🔌 Connectors, Jumper & Wire Quick Connector, Mounting Clips - For 5050 RGB LED Strip Light Review

Complete nonsense. I bought this kit to install magazines and it seemed to have everything I needed including extra lengths of wire to move between shelves in my project. As of April, half of the plugs I use have slipped or just don't work. I had to test each with a multimeter to make sure it could conduct current. Very annoying and bad quality

I bought this kit because I am installing LED lights under kitchen cabinets and want to run an extension cord inside the cabinets to connect to the lightbulbs below. Unfortunately, I never managed to get the connections to work with just a cable. However, the shorter connectors where the light just goes under the pins worked, so I now have some light in the cabinets. Get ready for a late night snack without turning on the kitchen light :-)

I bought this to install lighting in children's rooms. Everything worked as advertised. The only problem I had was with the T-connectors. The lighting order didn't match what I had which got me in a big mess as to where the wires went into the wall. My light order was black, green, red and blue, but T is different. Maybe I set it that way. I also had three wires running across the room and found that the light was losing power at both ends so the colors would not match when using light-to-light

This was just what I needed to help me install LED strips under our kitchen cabinets. Everything fits right into the connectors and the RGB LED strip I used. I know these lights and connections are not going to move much since they are in a static environment in the house. The only thing I could really use was another one of those plastic EZ connectors. This one had three so I soldered one point but all I did was remove the right angle plastic clip that came with this one and solder an RGB wire

I have tried this cable and connector set with the WenTop 5050 LED strip Two main issues: The cable interface requires three hands to align the wire in the IDC module and then crimp it. The result does not transmit 12 volts, so the lighting does not work. A cable is useless if it cannot connect. And there is no plug to go from the cord to the WenTop power supply. It really works with this DIY hack. I played around for 3 hours and repeated the connections several times. Not good. Unlike American

Short and simple, cheap product and low quality. I got it working but the time it takes to make sure all the connectors and pins in them actually provide continuity is . just not worth it - sometimes I had to put a thin insert under the bar so that when the clamp closed there was good contact, sometimes I just had to stay in a certain direction/angle, .- Even when everything is set and ready, . A small touch or accidental collision with it will cause one or more colors to be lost. If this…