🔩 Black Nylon License Plate Fastener by Custom Accessories 93342 Review

They were very tight, could hardly be screwed together. I had to hand tighten them to the bolt and then unscrew them until they finally held the license plate.

Fairly expected nylon fittings but the quality turned out to be worse than I expected. $6 for a set of mounts? Just head to your local hardware store to get the right nuts and bolts for a fraction of the cost.

I bought these for my motorcycle after one of my metal bolts broke off from vibration. The nut is too small, it deforms and falls halfway into the bracket. Should include a washer or make the nut slightly larger to avoid these problems.

Worked great easy to install until I had to change license plates. The bolts on the front of the car broke, dried out and fell apart and had to be thrown away. The ones at the back are barely holding on.

Not like the picture. Shows what looks like coarse thread wood screws (maybe 12 threads per screw in the picture) - for screwing into plastic where there is no thread - what I need for my front license plate. I have mounting screws that you would use for a threaded hole (maybe 18 threads per screw) - which I already bought for my rear license plate. The model numbers match, so Revain did NOT supply the wrong item. Check out my photo what you actually get.