Enhance Your Decal Application: Micro Scale Micro Sol 102 + Micro Set 101 Package Decal Setting Solution Review

These products have been used forever and honestly the amount received will last forever. These are good products, but not for beginners, you have to practice and pay attention. Cheaper decals tear easily, but the finished look of a well applied decal is worth it. I recommend watching YouTube videos and practicing with crappy models and decals.

I received these solutions for my WH40k models. I've always had a problem with falling or breaking water transfers, but not with this product. Combine this with a clear matte varnish and your translations are virtually indestructible. Make sure you are happy with where you are applying the decal as once it has cured the decal will be very difficult to remove.

I've heard about Micro-Set and Micro-Sol for a long time and thought they couldn't be that special. After another wrinkle on the sticker, I finally decided to give it a try. You are phenomenal. The micro kit helps stick the sticker on the mini; If you apply it liberally to the back of the decal, the decal will come off much faster than soaking it in water. However, the magic really happens on the microsol. The videos I've watched show that around 4 coats are usually needed and this may be…

These two solutions are very effective for applying decals. I've read and often use acrylic sealer (pledge) over matte paint to give a smooth finish before applying the decal. Applying a second coat of cling film and then general spraying over a flat surface will make the edges of the decal invisible. Micro-soll creases the release liner so it can sit on ledges (ie rivets) or in indentations (ie scrape the edges of the wood). Never try to work with decals at this stage. She will be destroyed. I

In the foreword I state that I am just a novice or novice Gundam/Gunpla builder. Some decals are just crazy about curves and wraps, think circles and angled arcs. This product will work but it just doesn't hold up that well and I still see silver plating pretty much everywhere and that goes for primed, painted and sealed and relatively flat surfaces. I switched to Mr. Mark Softer and Setter and it really is night and day. The stickers really stick and wrap around surfaces, maybe too well. I…

I was having a horrible time peeling all the waterslide decals off my model until I did a little research and found this. It is a must*. Here is my workflow: - Put the decal in water for 10 seconds, then set it aside. — While the decal is peeling off, apply Micro Set to the model with a small brush. - Use a toothpick to position the sticker from the backing on the model - Blot excess liquid from under the sticker or the area around it with a cotton swab - Let the sticker sit for a few minutes -