DEWALT DW3984 24TPI Portable Blade Review

I should have bought 18t/day. This blade takes too long to cut through a thick piece of metal, a nice clean cut for electrical wiring and unistrutt.

Note the tooth direction, I fitted one and it turned out to be reversed. It ruined the blade. The next one was the same, so I turned it inside out. Never had such a problem.

These plates are scrap. I can't believe they get five stars. I bought this pack a few months ago and used the blade about 4 times and it was dark. Put on another blade and then the blade on just a few cuts. I have a Milwaukee band saw and will be using their blades.

I bought it with a DeWalt portable band saw. The blade in the saw did a good job cutting medium-hard steel, so I judge my enjoyment of the replacement parts by the fact that I don't need them - the same blade went into the saw and is still cutting. happy together.

I bought a new Dewalt portable band saw and this set of 3 replacement blades. The saw's blade lasted quite a long time, cutting hardened 2 7/8 inch oil field tubing. The new blade didn't make a single cut in the 1/8" and 2" angle iron before the teeth were completely worn out. Since the blade is not heat treated, I will look around for blades from other manufacturers.

These are SUPER cheap -- useless -- saw blades. ...I was able (thanks to the saw itself) to make decent straight cuts - nine of them. Three Blades. By the third cut (on each blade) the teeth weren't just flattened, they were gone. Every time I use this saw it costs $2 a cut, I can't justify the price in any way. I hope there are better wheels on the market.

We use these saw blades all the time for cutting pipe and spacers. They are excellent value for money and I have three more packs of these. We haven't had any blade breakage issues at all. Make sure your TPI matches the thickness of the material you are cutting! With it, your blades will last longer and your haircut will be easier! I will definitely buy them again.

I bought a new Dewalt portable band saw and this set of 3 replacement blades. The saw's blade lasted quite a long time, cutting 2 7/8" hardened oil field tubing. The new blade didn't make a single cut in the 1/8" and 2" angle iron before the teeth were fully worn out. Since the blade without is heat treatment, I will look for blades from other manufacturers.

These are SUPER cheap - useless - saw blades. to make decent straight cuts (thanks to the saw itself) - nine of them. With three blades. By the third cut (on each blade) the teeth weren't just flattened, they were gone. When they charge $2 a cut every time I use this saw, there's no way I can justify the price. I hope there are better canvases on the market.