🚤 Waterproof LCD Inductive Marine Motorcycle ATV Snowmobile Boat Hour Meter – discoGoods Review

Solid machine! I am happy with the quality. At least outside. But there are no instructions, so here's how to install it. There is a slot on the back of the meter. Insert one end of the wire into this slot so that the entire slot is inside. Insert it deep into the slot. Then wrap the rest of the wire around the spark plug wire. I used 6 turns and cut off a wire I don't need. More or fewer wraps can also work. I used (3M Scotch 5952 VHB tape) to attach it and it held, but since I supplied the…

Installation was easy although no installation instructions were provided. I installed three other inductive hour meters, so this one was no different. I'm not sure how many times to wrap the signal wire around the spark plug wire. The instructions for my previous meters recommend five to six wraps. I used zip ties to hold the wire in place, duct tape can also be used. I wish it showed RPM better just because my other devices are showing and I'd like to see what the RPM is when the engine is…

nonsense! Big cheap OTHER MAN! I immediately noticed that there were no fasteners in the box, latch 1. When installed, the cable slot on the back of the hour meter is too wide to hold the cable and when the engine is running the cable dangles, latch 2 the description said the hour meter has double sided tape to secure it when installed, no. Plus once I installed it on my new generator and ran it. The LCD has turned blue and the screen is now difficult to read. hit 3! I've always had very good…

I've spent about 3.3 hours on this so far. The cable supplied is heat resistant, as is the insulation around the spark plug wire. Use the included cable to tap the connector cable behind the connector cap 4-5 times, then route the remaining cable to where you want to mount the clock using as much of the included heat-resistant cable as you pass hot areas . Block. Once you get out of the block area, add more 22 gauge to 18 gauge wire of whatever you have that will be wedged into the groove…

Nice little device. I used on my little generator. Excellent price. It is useful to know when to change the oil and how many hours your equipment is running. Installs it with double-sided tape for a neat look. (Red = Strong) Wrap and tie the spark plug wire or use tape to make it less visible and have better contact. And enjoy! Suggestion to the seller: make it so that he can turn back / turn back the clock. No visible button, just those tiny holes that you insert a paper clip in and hold for…

I was disappointed when I received the LCD timer. It came in a small bubble wrap box, with no zip ties or instructions on how to install it. If I didn't see how to install it on YouTube I wouldn't have a clue. This type of gauge uses an induction wire that is wrapped around the spark plug wire five times and the other end inserted into a slot on the gauge. I installed this on my tractor mower where the spark plug is on the front of the engine. The induction cord was too short to run the wire…