DOWELL Magnetic Different 180°Measuring Resistant Review

When using a spirit level on a board etc., one side of the spirit level shows the spirit level, but when you rotate or lay from the same place to the other side the level, it shows something else. That means you'll never know if it's a level or not. They have good service but still not worthy.

I think 1/3 of these were leveled accurately and I didn't bother to check plumb or 45°. The vials are attached to the plastic, but the metal and magnet won't stick to the walls. They should be distributed to employees to improve the quality of work. Luckily I noticed before they did the opposite!

Very well built and reliable. I bought it to level my 32ft caravan when I get to my campsite. The first time I used it I left it on my trailer frame and drove 370 miles home. When I got home it was still where I magnetized it to my frame. My mind was overwhelmed. In general very satisfied!

Got 2 pieces and both pieces don't even fit together when laid flat so I don't know which one is correct. Most likely, both will make a bad read. Tried it on a clean marble slab and then on a clean glass slab. But both read well when placed sideways, meaning only one side of the piece of metal is touching the surface. It turned out that the yellow plastic part has a bulge, so the metal part does not fully adhere to the surface in the horizontal position.

This is a level. This is its only function. Unfortunately, the thing was never calibrated and doesn't work. It's cheaply made and the bladder component is messily bolted to the block. I expect the level to be accurate and how a level works. This might work as a good paperweight, but that's about it. To be clear, the way you check the bubble level is to lay it on a flat surface and prop one end up until the bubble touches the line on one side. Then flip the layer. If calibrated correctly, the…

Can't read exactly. Doesn't fit exactly. piece of trash. You can't use it to get something to level up. Depending on how you mount it on the object you're leveling, it will tell you it's level when it's sitting on its narrow base. Put him on his side and he says one side is too high. Put it on the other side and the same side is now too low.

Got 2 pieces and both pieces don't even fit together when laid flat so don't know which one is right. Most likely, both will make a bad read. Tried it on a clean marble slab and then on a clean glass slab. But both read well when placed sideways, meaning only one side of the piece of metal is touching the surface. It turned out that the yellow plastic part has a bulge, so the metal part does not fully adhere to the surface in the horizontal position.

Stupid, I thought I couldn't get by at that price. But China strikes again. No level is exact. Checking the accuracy of spirit levels is very easy: you just place them on the table, check the position of the bubble, rotate it 180 degrees, and if the bubble is not in the same place, it will not show the "level" on. . None of them are accurate and they have those fake screws that give the impression they are for fine adjustment or at least allow the user to open the case to find the adjustment…