DS18 DPIV1/0 Dual 1/0 Gauge to 1/0 Gauge Amp Input Reducers: Enhanced Power Distribution Solution with Offset Stub Review

Overall this is a great product. The build quality is excellent and the weight is good. I just hate that they were too big for my Taramps Smart 3.

Feel-good set screws hold the wire well and fit large 1/0 ga wires if needed. I used them for all 3 12V+ and all 3 ground of my amp. They work fine. would recommend.

These things are good! Very high quality. I like that they are staggered so they don't get in the way of your other connections and wires, and it helps to separate the positive and negative to avoid shorts.

I have a total of 8 pairs of inputs for two 1/0 gauge amps. These imports are by far the most enjoyable of them all. The quality is second to none and the polished finish looks great. Quality can only be judged by weight. I will definitely buy more

Packaging says "Made in China". Other than that I think I got a good product for the money. Everything was exactly as advertised. I used 1/0 wire and it fitted easily. The flat surfaces on the standoffs were flat and square so they fit perfectly into the amp's terminals.

Well they are very well made. I have used them on the positive side of the knu koncepts battery clamps (the battery clamp only came 1 gauge 8 4 and 1/0). That way I could run a 1/0 from the alternator to the positive terminal and then a 2nd open to the rear of the car to power my two amps. Requires a 1/0 tip, so that's a big plus. This thing cleaned up my install.

So I get this package in the mail. The little box is deceptively heavy. I only open it to find these lovely DIY adapters. (I ordered two sets of Orion XTR 4000.1 amps) They are worth the price I paid for them. (especially compared to shcha) If you need an adapter of this type, feel free to buy it. I highly recommend them. I will buy more if needed. If I had to be picky, it would be the 1/0 wire hole diameter. the hole is a bit big. A 2/0 cable can be plugged into this connector. This connector…