ELEVATED AUTO STYLING Middle American Review

You have to press hard for it to stick. I had a little problem in the corner but otherwise everything was fine. Clean the jar, place it, then squeeze out the living trash to make it stick! Tried 2 corners and both pulled out so it wasn't just one side.

Not the easiest install. You have to work really hard to make it stick to the window and it's difficult to get it straight. It also blocks the view when looking in the rear-view mirror. You can't see much of what might be on the lane directly behind you.

This sticker with the American flag on the small rear window looks really great. The black against the black tinted window actually gives the impression of being etched into the glass. Tons of compliments! I love how I feel like I'm driving, like a little veil of privacy from those right behind me. It took a few tries to get started properly, but move slowly, take your time. Everything is ready in 5 minutes!

I love this addition to the truck. Bought for the new Superduty Ford and it fits perfectly. Yes, it does somewhat block the view through the center rear window, but that's why you have side mirrors on your truck. I love this understated look! Installation was easy. Spray some glass cleaner foam on the window so you can move the sticker. Put it back in place and scrape off the remaining glass cleaner. Boom!

Perfect! I sprayed some window cleaner on the glass to align the decal where I wanted it. I used the included scraper to work out the window cleaner and soaked it up with a paper towel. I left it in direct sunlight and removed the rollback. A heat gun or hair dryer works well in colder climates. It takes patience. After removing the backing, use a squeegee to remove any remaining window cleaner underneath the decal. A credit card is ideal for this. Be patient, take your time and everything will

The film is peeling off on both sides. I have followed all the instructions. Clean the window, apply the decal, hold one side while removing the inner (window side) backing from the other side, then remove the backing from the opposite side. Then use the included squeegee to smooth out the bubbles. Everything was fine at the moment. The sticker is in place, sticks to the window, no bubbles. The final step is to remove the outer foil. This is where the product fails - miserably. The sticker…

First I followed the instructions step by step. I know that a person who follows instructions is rare. But again step by step. The first problem I had was that the instructions said "apply the top half of the sticker first". Well when I opened the package the sticker was split left and right instead of up and down. It's okay, I continued. I started on the left side first and then moved to the right. Everything seemed to be going well. second problem. The sticker didn't stick! I started peeling…

The title says it all. When I applied this the streaks were perfect, no bubbles, no wrinkles. However, the INSIDE corners of some launches were bent and formed large lumps. It looked terrible. I'm sure the clumps will stick to the seal when opening/closing the window so I removed the sticker. I wrote to the seller but received no reply. Very disappointing. UPDATE 5/13/21 Looks like the seller sent me another one. I can't in good conscience give my 2 star rating after this level of customer…