Efficient Engraving with Proxxon FBS 240/E 28472: Durable Precision Engraver Review

In general, a great thing. I wanted to buy a Dremel in general (I have to cut, drill, grind small crafts), but the reviews alerted me (reliability is lame). I bought a proxon - a wonderful device. Some pros: A good machine, the speed does not sag, it is convenient to work. Different cons: Warming up. It is difficult to call this a disadvantage, after all, the speed is high, but it worked for 20 minutes and the machine is noticeably warm, closer to hot.

Lightweight, powerful machine. Very comfortable. When compared to the Dremel (4000 and 8220), the proxxon gives the impression of a working machine, not a hobby one.

Pros: Light and comfortable, good torque even at low speeds, not noisy, without vibration and resonance. Different cons: The equipment in the kit is so-so., I took a set from a dremel .

This is the first power tool that I am not afraid to hold in my hands and work with it :D I do not regret that I chose Proxxon as a gift for my husband, in the end I joined myself :D Its pros: Gorgeous machine! The quality is top notch, no complaints. Quiet and easy to work with. The three-jaw chuck clamps a wide range of shanks in width - from 0.3 to 3.2 mm, so there are no problems with consumables at all - nozzles from any drills (engravers, mini-drills) are suitable. Although you can put a

Some pros: German quality. no runouts either in the chuck or in the collet flexible shaft Has cons: high price, even higher than that of a dremel . not enough power (100 watts) but this disadvantage is compensated by the constant speed with increasing load.