Eureka AS-2000 Series Upright Vacuum Long Life Belts: 2 Pack - Part No. 83797: Top Quality Replacement Review

It made a HUGE difference - my vacuum was losing power and it was obvious the roller brush wasn't working. After replacing the belt and cleaning the roller, my vacuum is like new! Installation Notes Try to stretch the b4 belt slightly when installing; this will make assembly much easier =]

My son has a Eureka vacuum and the belt broke. He asked me to fix it and I sent AS2000 for the belt. The replacement was easy and the strap fitted perfectly. The vacuum sucks really weak but the belt lets the roller work and he was happy. It has a spare strap when there is enough vacuum for another spare.

I have a pet Eureka Airspeed that is several years old. Since the belt broke, I ordered a replacement. I just matched the belt number to the one I had. They fit and work well. It was right but not too crowded. I figured it would be best to put it on the crossbar first, then around the motor book, and then place the crossbar where it belongs. All in all it was what I was looking for and it lasted 4 or 5 suction cycles.

Terrible belt. Since the previous belt lasted about a year and a half, the brush needed a thorough cleaning. I cleaned the brushes and lubricated the bearings so they spin freely. The first tape ran about 400 square feet (20 x 20) before the brush stopped rotating. The strap stretches like the old one. I put in a second one thinking the first belt was bad. The second lasted the same. Very bad quality.

The first strap broke almost immediately. I thought I did it wrong so I re-read the instructions and watched the video. Got a second one and worked the full 10 minutes before it broke again. The belt does NOT fit the Red Eureka Airspeed Pet. Thank god it's molting time and I have two double haired pets. I definitely didn't want my whole house NOT to be covered in hair right now.

Initially when I took it out of the box I almost immediately sent it back for a return. Compared to my old belt, this new belt was an inch or 1.5" smaller than the brush wheel. However, the belt is quite elastic, so I hand-tightened it well, then looped it over the motor and fed it to the brush. wheel, and put everything back in its place. I don't know how long it's been since the belt broke but my vacuum didn't work very well for several months. I found it by accident while doing a 6 month…