🌬️ Enhance Your PC Cooling with EZDIY-FAB 120mm RGB LED Case Fan - 5 Pack Set Review

I bought the fans earlier this year and they still work, but I've had problems with them. Pros: Price Very quiet fans but low speed Multiple hook methods depending on setup Cons: Fan wiring is cheap and easy to break it route fan connectors are also cheap and easy to break. In my situation, my RGB lights went out intermittently. They worked well, but the bulbs were constantly bugging. I contacted the manufacturer to see if I could get help on this and was left with no help. Keep this to…

Update: One of the fans is making a terrible scratching noise. You get what you pay for. I won't even contact support, just buy a better set of fans. At first I was skeptical about buying them. Some reviews stated that not all fans would spin or not work at all. I must be lucky because these fans are incredible. They're a bit noisy, but the anti-vibration pads help a lot and you won't be able to hear them when using a headset. The airflow is unbeatable for the price. Didn't lower temperatures…

Installation was tricky, I won't lie, the inside where you screw in each screw wasn't done right which means plastic prevents the screw from going in properly once you've used the screws that came with the kit, it didn't fit at first and at some point when screwing it in there was a lot of resistance, I had the feeling I was about to break the fan frame, so I had to take a screw from Noctua and screw it in so that it lays like this and adjusts the fan for the standard screws it comes with…

I bought these fans as an alternative to well known brands like Corsair or Thermaltake. The fans look great and have more lighting modes than I could ever care about. The only complaint is that the fans are controlled by the hub. So when the hub dies, so do your fans. The fan speed is not adjustable and the fans running at full speed are a bit noisy in my opinion. However, the fans themselves actually move a decent amount of air and keep my build as cool as my Artic F12 fans.

Cheap Control Only one LED fan works with LED light; After working with support a second controller was sent to avoid damaging the controller. I recommend peeling the adhesive to remove the two screws holding the controller together and seating all fans securely, but being careful to ensure the slots are populated in numerical order. This is important because otherwise you have to insert the connector to the left until it breaks because it is not flush with the outer edge of the controller…