💡 EZDIY-FAB 5V ARGB Memory RAM Cooler - Enhance DIY PC Gaming Performance with DDR3/DDR4 Heatsink (2-Pack) - Compatible with ASUS Aura Sync, GIGABYTE RGB Fusion, and MSI Mystic Light Sync Review

I ordered two kits which once assembled should be four complete pieces. Eight pages, two for each lamb and corresponding ropes. What I got were the side panels, all crammed into the box with half the cables missing, with no instructions, not to mention I actually needed them because I couldn't use them anyway. It definitely looks like someone ordered it and then only sent half of it back and then it was accidentally sent to me. Yes accidents happen but it's a bit ridiculous, definitely need a…

Comes with two thermal pads (four total) if the memory chips are on both sides of the module. Also comes with plastic standoffs in case the memory chips are only on one side. Brightness is as expected and works well with the RGB controllers I use. A little pricey in my opinion, but not too bad when you add the shape (LEDs). ) and function (heat spreader).

very nice! If you're worried about the LED wires shorting out the memory card, simply run a piece of electrical tape across the top of the memory card so the tape curls up on both sides of the memory card.

The colors are really bright and washed out, the only thing you notice if you look closely is a part in the middle on both sides I thought it was rounded but it is is just an aesthetic look, plus everything else is fine, just plug it into your motherboard and they were fine, no complaints here

Overall I am very satisfied with this product. The hardest part was managing the thermal tape, but otherwise the installation was easy. They're bright and work great with RGB Fusion.

I got this "EZDIY-FAB 5V ARGB Memory RAM Cooler DDR Heatsink" to try. I ended up removing it because the extra cable is really a mess - there just isn't an easy way to hide them because they have to be on the top of the motherboard. In terms of cost, this kit is also a bit pricey. It would be much easier to get native RGB memory instead. No, I do not recommend this product. Thank you for reading this review and I hope you find it helpful.

I ordered two sets which should be four complete pieces once assembled. Eight pages, two for each lamb and corresponding ropes. What I got were the side pieces, all crammed together in the box, half the cables missing, with no instructions, not to mention I actually needed them because I couldn't use them anyway. It definitely looks like someone ordered it and then only sent half of it back and then it was accidentally sent to me. Yes accidents happen but it's a bit ridiculous, definitely need…

This was a very easy install. I think the hardest part was removing my old radiator. A quick note on this if your RAM isn't a heatsinkless dimmer: look at reviews or videos of people stripping both sides of a heatsink to see which kit you have. With the kit I had, the Patriot Viper Steel, you can only remove one side of the radiator. Luckily I swapped kits with my roommate as we were the same speed and they were going well. The wires were a little tricky to route where they weren't visible, but