🔥 Enhance and Cool: EZDIY-FAB 12V RGB Memory RAM Cooler - Compatible with ASUS Aura Sync, MSI Mystic Light Sync, ASRock Polychrome - Black-2 Pack Review

Contrary to the description and what others have complained about, the red and blue are NOT reversed. They are accurate and perfectly in sync with the correct colors that match the colors on my MSI motherboard and what the Mystic Light software calls it. So I don't know what everyone's little problem is, unless it's not properly connected to your motherboard. I ordered this and the NVMe backlit heatsink in the 12V version as I only have a 4-pin RGB header. Initially, I didn't want to remove the

I wanted to buy a new RAM because I wanted it with RGB. However, I'm so glad I found this because it gives me the look I want without breaking the bank. First, it is very easy to install. The kit includes 2 strips of thermal grease, 1 gasket and an extra screw. To install, simply unscrew the 2 screws from the heatsink. On my own, I applied a strip of thermal paste to both sides of the heatsink, laid the RAM to one side, plugged it back together, and screwed it in place. That's all. My…

If you can afford high end RAM with shiny lights you won't be reading this, these things are good. They're not addressable RGB LEDs, they're more like a strip of light in a plastic tube. You want shiny neon lights for your RIG, this is your GO-TO, if you want bells and whistles spend an extra 500 for the top of the line. These works, I love them. Too bad the seller didn't engrave the product, but he can't complain about the cost!

In August 2017 I bought a non-RGB Trident Z-RAM for almost $200 for 2 x 8GB 3200 speedsticks and the RGB premium was ridiculous at the time so I have the nons -Get RGB version. Also because the software to run them would conflict with my Corsair ecosystem. Fast forward to February 2019 and I find out I can make any RGB RAM? And with the appropriate strips and cables to get them working through my Corsair control program? count me So I replaced some of the 4mm ARGB strips I was using on the back

Just make sure you position the sticks so the wires come out the top of the board. I had to shorten the cables connecting the other sticks as there is no need for 4 long cables when they all have a straight through connector that easily connects together. If you are using an RGB controller I would recommend this one https://www.amazon.com/gp/product/B07PJNYLWQ/ref=ppx_yo_dt_b_asin_title_o01_s00?ie=UTF8&th=1 as it has a wider range of colors than I do compared to others tries. Fix it and it will