EZDIY FAB Memory Heatsink Compatible Pack PI061 Review

Very Nice! If you're worried about the LED wires shorting out the memory card, simply run a piece of electrical tape across the top of the memory card so the tape curls up on both sides of the memory card.

Overall I am very satisfied with this product. The hardest part was managing the thermal tape, but otherwise the installation was easy. They're bright and work great with RGB Fusion.

Comes with two thermal pads per set (four total) if memory chips are on both sides of the module. Also comes with plastic standoffs in case the memory chips are only on one side. Brightness is as expected and works well with the RGB controllers I use. A little pricey in my opinion, but not too bad when you add the shape (LEDs). ) and function (heat spreader).

I have ordered two kits which when assembled should contain four complete parts. Eight pages, two for each lamb and corresponding ropes. What I got were the side panels, all crammed into the box with half the cables missing, with no instructions, not to mention I actually needed them because I couldn't use them anyway. It definitely looks like someone ordered it and then only sent half of it back and then it was accidentally sent to me. Yes accidents happen but it's a bit ridiculous, definitely

Very easy to fit and connect and looks fantastic in style, color and shape! And all that at a reasonable price for a pair of around 20 euros. This is a must have for RGB enthusiasts! I'm so so happy again!

I got this "EZDIY-FAB 5V ARGB Memory RAM Cooler DDR Heatsink" to try. I ended up removing it because the extra cable is really a mess - there just isn't an easy way to hide them because they have to be on the top of the motherboard. In terms of cost, this kit is also a bit pricey. It would be much easier to get native RGB memory instead. No, I do not recommend this product. Thank you for reading this review and I hope you find it helpful.

I have ordered two kits which should make four complete parts when assembled. Eight pages, two for each lamb and corresponding ropes. What I got were the side pieces, all crammed into the box, half the cables were missing, no instructions, not to mention I actually needed them because I couldn't use them anyway. It definitely looks like someone ordered it and then only sent half of it back and then it was accidentally sent to me. Yes accidents happen but it's a bit ridiculous, definitely need a

It was a very easy install. I think the hardest part was removing my old radiator. A quick note on this if your RAM isn't a heatsinkless dimmer: look at reviews or videos of people stripping both sides of a heatsink to see which kit you have. With the kit I had, the Patriot Viper Steel, you can only remove one side of the radiator. Luckily I swapped kits with my roommate as we were the same speed and they were going well. The wires were a bit tricky to route where they weren't visible, but it's