🚀 Gigabyte GV-N3080TURBO-10GD GeForce RTX 3080 Turbo 10G rev 2.0 LHR, 10GB GDDR6X, High Performance Graphics Card with Enhanced Durability Review

The card can be used normally only by fixing the voltage at 0.8v at 1.77 GHz and setting the cooler to 100% at 85 degrees - with these settings, the card heats up in heavy games (Metro Exodus, RDR2) up to 78 for the core and 90 for the memory, with a fan speed of 70 -75% (normal noise). At the same time, the FPS is even higher by one or two percent than if you play without changing anything (the card does not throttle due to overheating). Power consumption drops from 325 to ~260 watts. If you…

The performance is excellent like all 3080s, compact, but it’s better not to put it in a small case)). The turbine does not cope with the temper of the card, it quickly heats up to 89 g and this is in a spacious case, the turbine is set to a gentle mode from the factory and the card is saved from overheating by resetting often, which immediately results in sharp drops in FPS. When the rpm is increased to 100%, the card cools down a bit, to about 82, but starts to make wild noise. Downvolt to…

As a result, a wonderful card with the right approach (undervolting, setting the VC curve, and so on) does not heat up above 75 in the same cyberpunk. Considering the situation on the market, it will last for 3-5 years, if salted correctly :) I recommend to buy, I'm not sure that in the near future the card will be missed. Pros below: Excellent card, powerful, fast, 50-60 fps in heavy toys (cyberpunk in 2k and insane RTX 50-60 without noticeable drawdowns) With its cons: Mandatory undervolting…

In general, a good video card, the performance is on par with all 3080s. But since its size is small, and the cooling system is made in the form of a turbine, the video is noisy, it’s understandably inaudible in headphones and there is no difference, but it’s noisy, maybe a little quieter than PS4 pro in demanding games. However, here is the plus of this video card, you can easily put it in a compact case, you can put two side by side, they will take only 4 slots, but they will make noise, be…

After installation, I recommend changing the fan settings I also advise you to install thermal pads around the GPU on the backplate of the card: the thickness should be 3mm-5 or thicker, otherwise it will not reach the wall from the PCB to transfer heat Its pros: Relatively quiet Moderately hot Turbine control settings curves in default (with them the card in stresstests warmed up to 88 degrees), after the settings the peak temperature became no higher than 71. In idle, no higher than 49 Cons…