Glarks Connectors Gold Plated Surveillance Transmission Review

The quality control is quite poor, the materials are of poor quality and the workmanship leaves a lot to be desired. Several screws were stripped so I had to solder the center conductor instead. The threads for the back shell were very poorly formed and felt gritty. However, they are one of the few solder (as opposed to crimp) BNC connectors available. They work but aren't pretty.

I needed 14 gauge braided cable for a single speaker for some test cords and that worked for me. I like the fact that they come in a small plastic box that can be reused for small items after using the connectors. The 14 gauge wire is too thick to fit into the socket where it normally screws on, so instead I just soldered it to the terminal and then covered the exposed wire with heat shrink tubing and crimped it. I would recommend them.

I've been doing BNC wiring since 10base2, but the last few years I've had to do almost nothing. My problem with this is quality control. There is a set screw for the middle conductor. (middle wire) More than half of these were removed because the screw was overtightened in production. IOW, useless as you can't remove the screw to insert the center wire. Luckily I only needed 2 for this job and I was able to get 2 out of 15 working properly. I do not recommend this product to anyone and will not