🔧 GOOACC 40PCS Nylon Bumper Fastener Rivet Clips - Car Door Clip Panel Audio Video Dashboard Dismantle Kits Installer Pry Tool Review

I used these brackets to replace some worn brackets on my 2002 Honda Rancher ES. They worked great. In case anyone is wondering, the head of this clasp is slightly larger in circumference than the head of the clasps that originally came on my quad. I really don't mind as I bought them for their function and not their looks.

Disposable retainer. The head of the needle is thin. It only flexes when I use a flathead screwdriver. The stylus is firmly seated in the holder and I only expect problems removing it. Over time the plastic gets brittle, these heads just snap off and I have to drill them out if they don't fall off. too much trouble The price does not justify future problems Good car parts, the seller does not accept returns, which is not noticeable in the description.

Uses these on my 2006 Honda Recon ATV. They worked better than the OEM clips and even if the holes are a bit longer they still provide a good fit as they stretch more than the OEM clips. It's also important to note that the part that usually breaks (the head inside) is reinforced under the head, so they'll probably last quite a while too. The plug heads are bigger than the small ones you usually see and I like that better too. All in all, you can't go wrong with them. Oh, and that's for 8mm…

They come loose so it's actually 40 pieces. I want to make this clear as many vendors exaggerate the situation. Well done and just a few unfinished castings. Good buy. Full Story: I had to remove the front fender trim on my old car to get to the fuel system and then found that I had to buy parts. That night we had a storm that blew away all the fasteners. I ordered them and they just fitted in. I can easily understand why automakers like them so much. Just a few minutes and everything is back…

I have a 2012 Chevy Traverse and needed some new under the hood skirt clips. I had to replace the front upper grille due to damage and as part of the replacement I had to remove the front bumper, as part of the removal I had to remove the under hood apron. These clips were holding the skirt, and because I didn't have the right tool to remove them, I broke a few. These clamps fit snugly and were easy to install. Another important point is that my car uses the same clamps in many different areas.

I have tried to reuse old bumper cover fasteners in the past but was disappointed. On my older cars they usually broke and then I just didn't use them or zip tie them. Because these latches are so cheap I bought a couple of bags to use with our 2006/2007 Civic and 2004 Odyssey. They work better than any other fasteners I've tried. I bought another multi size kit which was basically useless. They've worked great on every Honda I've tried, as well as the Chevy Cavalier, Chevy Impala, and Toyota…

I have a 2016 Ford Mustang and I bent the fender a bit which broke my car's built in clips. They were recommended to me by a friend who used them for the same reason. Nothing looks as perfect now as it did before the crash, but they are secondary, they are very easy to insert and give the impression that the bumper has suffered very little damage. As you can see in the photos, the first picture is the before (no clamps) and the second is the after (clamps installed). They work very well (press…