🛁 Effortless Assembly: Greenspring Stainless Bathroom Matching Set Review

I have had different faucets over the years and this one is the best. My previous faucet was an Axor Handsgrohe and was leaking. Put in a new cartridge and the cost was more than replacing the entire faucet. When I saw the price in Revain I ordered it. The entire faucet is made of stainless steel and is chrome-plated. No plastic components. And I like the pop up drain. Would recommend to all luxury condos.

This faucet has a nice and modern look. We had two installation issues: 1. The center post for the installation was too large for the standard hole at the top of the vanity. I had to use a large drill to cut the hole until this faucet fit. 2. The plate on the bottom that holds the faucet to the sink is small - it all comes loose if you wiggle the handle vigorously. I wouldn't buy this again, I've had no issues with brand name fittings.

I ordered one of these for a downstairs bathroom renovation in 2018 and loved the look and ease of installation. I ordered another one in 2019 to renovate the upstairs bathroom. Right now (1/2021) the top floor was dripping all over my closet and we found mold. Looks like it's been leaking for a long time. I went downstairs to check out the other one and sure enough there are water drops on the propellers. After you remove both, there is moisture in the faucets themselves, so it's not a…

We have a double sink in the master bathroom. One faucet was leaking so both were replaced. This faucet is great. It is glossy and has clean lines. We bought the one that has a drain plug and it's the kind where you push the plug instead of the handle on the back. I installed it professionally so I'm not sure how difficult it is to install. The faucet provides a strong flow of water, and if you have a small sink, it can splash over the edge. Once you get used to the correct flow, this should…

Very nice single lever mixer. I had to cut a hole in the pool with a saber saw for the pipes and screws to fit. I used a washer to mark where the screws are in the way of the sink, luckily it's a faux marble sink and I was able to carve notches backwards with a fine saber saw. Then it went great. I had to apply teflon tape, but I was able to use a gasket on the drain pipe's main threads to prevent it from leaking, even after the nut was tight enough. I read that there is noise (probably…

Arrived very well packaged. The quality seems excellent. Didn't come with a top plate gasket so I just used plumber's putty to make a seal in case of water ingress. The faucet has a gasket/seal on the top plate. Pretty simple build. Here's a hint! Use a 10mm socket wrench to tighten the nuts. This will help you a lot and make the installation much easier! Another tip is to clean all threads with a cloth or cotton swab. I noticed a lot of metal shavings inside. I would also remove the aerator…

I would like to say that this is a very well made product, it is of good weight and the lever works smoothly. I read a few reviews before buying it and I kept reading oh my god it's so loud change this or that lol I don't know what those people got but this faucet isn't as loud as the one that came with House. I think you need a small children's wash basin to solve the overflow problem. I have a full size adult double sink and the wide open water enters the sink a few inches below the overflow.