🔪 High-Quality 45 Degree Tungsten Steel Lettering Blade for Roland Cutter Plotter - Pack of 10 with Red Cap Review

This is GREAT! I just cut vinyl with the Cricut Air 2 and I think my Cricut blade was pretty dull making the vinyl impossible to weed. I decided to try and cut the vinyl, according to the reviews I lowered the settings to vinyl and iron and it was so severe it still cut through the backing sheet. I am very happy with the sharpness of the blade and hope they last a long time so I can save money on branded blades. Don't hesitate to buy!

Defective Chinese blades. Keep in mind that they cut quite deep - I use them at around 39g pressure, whereas in the past (with a well known brand, quality blades) I've worked at around 120g pressure. The life of the control blade is ridiculously short - Approximately 10% of the lifespan of high quality branded blades. I have a vinyl graphics business and used to be able to go a month (maybe longer) without changing blades, now I change them weekly if I'm lucky. They got my money once - never…

Я использую свое первое лезвие из этой упаковки уже более недели в бесчисленных проектах с картоном, ТВЧ и самоклеящимся винилом, и оно такое же острое, как и в first time. . However, they do seem to cut deeper than my other blades, so I had to set my machine to a lower setting for each material, for example when cutting HTV I used the sticky vinyl setting, otherwise it would cut through backing film in places. I advise you to make a few test cuts the first time you use the blades, otherwise…

The blades were neatly packaged and well protected. I bought them for the US Cutter MH871. I've only used 1 blade for a couple of projects and the blade still works like new.

Broken Chinese blades. Keep in mind that they cut quite deep - I use them at around 39g pressure, whereas in the past (with a well known brand, quality blades) I've worked at around 120g pressure. The main reason for the one star rating is that the rudder blade life is ridiculously short - about 10% of the life of high quality branded blades. I have a vinyl graphics business and used to be able to go a month (maybe longer) without changing blades, now I change them weekly if I'm lucky. They got

I've been using my first blade in this set for over a week on countless cardstock, HDTV and self-adhesive vinyl projects and it's as sharp as when I started. However, they do seem to cut deeper than my other blades, so I had to set my machine to a lower setting for each material, for example when cutting HTV I used the sticky vinyl setting, otherwise it would cut through backing film in places. I advise you to make a few test cuts the first time you use the blades, otherwise it's a great price…

These blades cut beautifully with my Cricut Maker. Some people have mentioned that the blades cut a little deeper than other blades, but I didn't notice that with the Maker. I cut regular copy paper first to make a test cut. I set the Cricut stock to copier paper - 20 lbs. The cut was clean and also the right depth. I then switched to 107lb shimmery cardstock with 350 cutting pressure and Multicut Off. (requires only 1 pass). As you can see from the photo, the HQ Master blade is excellent for…