🔍 NSI - 418F-ID Identification Marker Flag Cable Tie, 18 lbs Tensile Strength, 0.75" Bundle Diameter, 1.00" x 0.310" Marker, 0.100" Width, 4" Length Review

I've used these to mark computer and coax cables. I just wish they were a little bigger so I could write more information about each instead of abbreviating it.

The writing surface is smaller than I expected but 5 stars because the size was perfect. Just make sure you have an ultra-thin marker; The penalty is too large for the write area.

I've been using the Brother P-Touch Label Printer to label a variety of power and network cables, but I needed something faster to print different colors for unfinished basement tubing, wire and... to label cables. Along with retractable Sharpie ultra-fine permanent markers and 3 colored markers (1735794), I was able to quickly mark cold (blue marker) and hot (red marker) water pipes and indicate where they went. The same applies to the inlet and outlet of the reverse osmosis system for the…