Insulated Wire Electrical Connectors Assortment Review

You can't go wrong with this set. It comes in 3 sizes and about 6 different types so yes it's a win in my book. They have a high crimp strength which gives me confidence when using them. They don't crumble like others I've used.

So why did I buy a connector for wires? Are you connecting two wires correctly? Well, if you're going to do it, don't buy it. It doesn't work at all. After crimping, the wire can be easily separated with a slight jerk. The metal used is of very poor quality. What a waste of money.

Good price, bad quality. The insulators broke off when crimped. Tried a few others and the same result. I use brass and copper to make connectors. We used to joke about quality but I bought them from the company because they ended up being good quality. These just suck. My personal experience. Will get better ones and just pay a higher price.

Absolute junk. Be sure to check the crimp by pulling on the connection as they have a tendency to loosen when crimped with an insulated connector crimping tool, even if the connector has been crimped all the way around the wire. I found that if I used an uninsulated die on my crimping tool and crushed it, damn it, they basically held. I threw my set in the trash. These connectors can cause you a lot of trouble when troubleshooting loose connections.

Very low quality. I'll end up throwing them away or using them in a pinch until I find better connectors. This is one of those cases where I haven't carefully checked the reviews. It's just not what I'm used to. Really cheap quality. Read the content of the image carefully to make sure it suits your needs. There are no AWG #12 quick disconnects. Update May 18, 2020: Added images showing the difference between a decent roundabout and this one. This item is on the right side of the two photos.

I was in a hurry and didn't read the reviews. How tricky can a simple crimp connector be? Well the box was broken for starters! Everything looked fine until I removed the shrink wrap; Two attachment points were broken, meaning the lid won't hold up. And the connections are of the same quality; The rings are very small, forget about connecting with a decent screw. The metal will be crimped unevenly, one side will fail and the other will not hold the wire. The wire pulls out easily. In summary…

They work if you are in a place where you can use a heat gun. However, if you don't and have to use a lighter or flashlight, you'll melt and completely destroy the heat shrink tubing long before the solder begins to melt. Even with a heat gun, I feel like I'm heating it up three times longer than I need to. Just to see how quickly I could melt one of them with a small pocket torch like you get from a smoker, I turned it on full blast and aimed the flame directly at the solder. It took a good 10

Ordered this for my husband, very disappointed that Revain let the seller do it. The product was badly short-circuited. Ring lug #4 AWG 22-18, shipped 23 should be 25 Ring lug #8 AWG 22-18, shipped 24 should be 25 Ring lug #10 AWG 22-18, shipped 22 should be 25 Terminal block studs #8 AWG 16-14 shipped 17 should be 20 spade #4 AWG 22-18 shipped 18 should be 20 spade #8 AWG 22-18 shipped 11 should be 20 spade #8 AWG 16-14 shipped 12 must be 20 AWG 16- 14 butt connector Sent 3 must be 10 AWG be…