🔒 Upgrade Your Pickup Toolbox Security with JQuad Truck Tool Box Lock - Replacement Cylinder for Convenient Latch (1 Pack) - Comes with Keys Review

Installs in less than 5 minutes. Works well. If you're having trouble getting a wrench on the nut on your old cylinder, try tapping the edge of the nut with a flathead screwdriver and a small hammer until it spins free. You can tighten the new nut in the same way.

Finding the right lock for my truck tool box was a challenge. I would like to thank you for the promotional image with the exact measurements or measurements. It helped a lot to find the right lock that fit the first time. The lock fitted easily and worked like the original!

Installation was more difficult than expected. Due to the location of the nuts, I had to drill through two rivers to reach them with a wrench. Inserted a new one and I tightened the nut that brought the two points together. And the first time since I lost the key ten years ago. My toolbox is locked again.

They worked with both my truck tool kit and my trailer tool kit, 2 different companies make them but they fit perfectly, they aren't changes required. Really cut and set dry and the quality seems good and tight. Time will tell how long they last but even for that much money if they last a few years I'll be happy.

Bought a set of used Bestop Soft Doors for my Jeep TJ. But the guy didn't have the keys to the locks. Since Bestop's complete paddle handle and lock assembly was $80 each and these locks were a similar size, I decided to give it a try. The paw needed a bit of modification but they worked great for a fraction of the price.

Exact lock replacement for my truck's tool box. When I bought my used pickup truck complete with tool box, I didn't get the keys for the tool box. I should have ordered these a few years ago as I had my toolbox stolen several times while I was at work. They were trivially easy to install, and the same key opens both locks. Bye, Bandito Parking Lot!

The lock is the perfect replacement for the tool box in the bed of my pickup truck. The old lock on it wouldn't turn with a key, so I had to remove the deadbolt and pull out the old block. This device got up without any problems and has worked flawlessly. I can pull on the lid of my box like a possessed chimpanzee and it won't move at all. The key opens the lock with little resistance, locking and unlocking as intended with no problems. Feels sturdy, easily justifies the cost for the price…

Great lock and perfect replacement for my UWS Pickup Toolbox. The lock cylinder has flat sides on both sides, which fits perfectly with the flat circular hole in my tool box. This is not visible in the description and photos so I have attached a photo showing this. This design holds the cylinder in place and prevents it from turning without a key. The barrel locks sold at hardware stores (for drawer/cabinet use) are usually full circles and also don't have the right length of inner rods to fit…

Fits perfectly in the tool box latch on a 24 year old Challenger pickup. It took the place of the original and only took a few minutes to install. I didn't have the key to the original cylinder. It was CH-509. They came with a CH-501 key. I looked around and a new set of keys was about half the price elsewhere, but couldn't find free shipping, so it would cost about the same as replacing the whole cylinder with a new one. Key set with free shipping Revain Prime. If you own a lock of this type…