Header banner
Revain logoHome Page
πŸͺš kodiak cutting tools kct137718 diameter: the ultimate precision tool for efficient cutting logo

πŸͺš Kodiak Cutting Tools KCT137718 Diameter: The Ultimate Precision Tool for Efficient Cutting Review

4

Β·

Average

Revainrating 3 out of 5Β Β 
RatingΒ 
3.0
πŸ”§ Milling Accessories, πŸ”ͺ Cutting Tools

View on AmazonView on Π―M

Media

(3)
img 1 attached to πŸͺš Kodiak Cutting Tools KCT137718 Diameter: The Ultimate Precision Tool for Efficient Cutting
img 2 attached to πŸͺš Kodiak Cutting Tools KCT137718 Diameter: The Ultimate Precision Tool for Efficient Cutting
img 3 attached to πŸͺš Kodiak Cutting Tools KCT137718 Diameter: The Ultimate Precision Tool for Efficient Cutting

Description of πŸͺš Kodiak Cutting Tools KCT137718 Diameter: The Ultimate Precision Tool for Efficient Cutting

Premium Sub-Micrograin Carbide End Mill Made In the USA. Premium Sub-Micrograin Carbide End Mill Made In the USA. 1-5/8" Flute Length (Length of Cut), 30 Degree Helix. 4" Overall Length Center Cutting Carbide Endmill. 4 Flutes, Extra Long.

Reviews

Global ratings 4
  • 5
    2
  • 4
    0
  • 3
    0
  • 2
    0
  • 1
    2

Type of review

Revainrating 1 out of 5

The best end mill on Revain!

Works as it should, it's all about feed and speed, lots of greasing. I have many tools from this company and they have always worked well. Milled M2, stainless steel, titanium and inconell with good results. The tools are still sharp.

Pros
  • High quality micro grit carbide end mill Made in USA
Cons
  • weak

Revainrating 5 out of 5

No flat on shaft for bit holder locking screw

It cuts as said and works well. One surprise: all the end mills I've seen have a flat spot on the non-cutting portion of the cutter holder setscrew. That does not work. It does not work properly, the knife keeps rotating in the holder and is not round. give it back

Pros
  • Overall length 4" Carbide End Mill
Cons
  • I'll add later

Revainrating 1 out of 5

Cut it like butter. I can't comment on how well it cuts metal.

Very good for the lower half of an 80% polymer assault rifle that I needed to mill. Cut it like butter. I can't comment on how well it cuts metal, but it's perfect for a DIY Ar15 floor build.

Pros
  • 4 flutes, extra long
Cons
  • Big and bulky

Revainrating 5 out of 5

The best end mill on Revain!

Works as it should, it's all about feed and speed, lots of lubrication. I have many instruments from this company and they have always worked well. Machined M2, stainless steel, titanium & Inconell with good results Tools are still sharp.

Pros
  • 4" overall length Carbide end mill with center cutting edge
Cons
  • Wrinkled