Leviton 80301-SW 1-Gang Screwless Snap-On Mount Decora Plus Wallplate in White Review

Does exactly what it's supposed to. However, this is not an easy setup for a big-toed man. I found the screws to be a little shorter than I would have liked. I lost her twice. However, I was working on an older box with little headroom in a fairly tight space. People working in a new home are unlikely to experience the same problems.

I needed two wall panels. I read the information several times to find out how much "pacu" is. I couldn't find any information in the product description, so I assume it is. Four wall panels have just arrived. It should be clarified that there are two of these in 1 package! It seems like this could be a way to get us to resell and as this is a small item we will not deal with returns. Hence the low rating. Otherwise it would be 5.

One caveat: it says 'Snaps' on it. If you look at it, there's nothing it can do. If you look at the back, there are a couple of very short eyelets. Look at the cryptic diagram on the bag? Yes, you insert a small flat head screwdriver or knife blade and wiggle it and it splits into *two* pieces. The inner one has screw heads. It just seems to screw into the drywall a bit, so it's not very strong, but it doesn't need to be, does it?

Excellent decorative overlay, perfectly matched to the Leviton jack we bought with USB connectors. I like the way they look and these bezels don't show screws like traditional ones do. You simply snap onto the front of the screw-in part and close it. The result is a clean look that's slightly more upscale. I can't say anything negative about them. They are easy to install and much easier to clean than traditional electric ranges.

really cool looks after installation, nice clean lines. screwless plate means that the mounting screws are not visible after installation - no, but for installation - just the 2 device screws approx Phillips), place the rear mounting plate on the top screw first, then the bottom of the mounting plate snaps onto the bottom mounting screw and then tighten the screws until they are secure. Please note that the back panel has two sides, one side is marked "wall side" and "top side", so make sure to