MAGBIT 625 6616 MAG625 Carbide 16 Inch Review

I needed to drill a 4 1/8" diameter hole in brick trim over 1/2" plywood. I was a bit hesitant when choosing a hole saw due to the many good and bad reviews of different diamond hole saws. I "hold my breath" and bought this device based on "Revain Choice" status and it worked really well. My first thought was that I would need to hire a serious brick drill bit, but I started the hole with a Dewalt 1/2 inch notebook. This hole saw started to cut brick quite well even though I was using it dry. I

Used to cut 4 1/8" vent holes in Hardy Fiber Cement Finishing Board (1-thick concrete panel). . inch) and it worked! Watching your speed is important and if you are using a hand drill make sure it doesn't get stuck. Carbide grit works very well and does a great job of keeping debris to a minimum After cutting 4 perfect holes with a heavy duty commercial drill (not a hammer drill) the saw showed no wear.The saw cut through with minimal cracking on the back of the material.My only concern is that

As the title suggests, drilled a hole in a 2.5 inch thick brick wall. That's the only good thing I can say about him. From the bad: Initially when I tried to wrap it on my gazebo it was very tight. As soon as I started drilling it ruined my mandrel. The instructions stated that the pins in the mandrel were not to be used, just pushed up to the shoulder. The problem is that she removed the mandrel threads, which then required the use of pins to complete the work. It got very wobbly on the shaft…