Maxxima M09300RAS Round Clearance Auxiliary Review

These headlights are built into the side mirrors. I had to drill a hole and run the wires through the mirror itself to get them to the door, which was a lot of fun. But they look great and were worth all the work it took to install them. I like that they have a dimming function. This makes my truck more visible to cars in the lane next to me.

Product photo shows only 2 wires, M09300YAT has 3 wires which are used for the turn signals in addition to the parking lights. If you have Metal Cloak fenders for a Jeep, these appear to be the very headlights they use and sell (despite being a lot more expensive). They fit perfectly in their light hole! I have the 2006 Rubicon fenders and the Metal Cloak fenders for it, I cannot guarantee the Metal Cloak fenders for JK will have or use the same lights.

These lights are AMAZING. They are SUPER BRIGHT. They are very easy to install through a 0.75 inch hole. The picture is deceptive. It only shows 2 wires. if there are actually 3. one to stop, one to land, one to turn. At first it lit up, but didn't blink with a signal. Came to find out I had to switch the turn signal and tail light wires on this LED setup to make it work properly. A minor downside is that you end up with tons of wires. It remains to tie and secure with ribbons. But I would put…

These 3 wire LEDs make great running and turn signals on my 16 year old aluminum tubed Wrangler. Good quality, bright, easy to connect and now I have running lights AND additional hazard lights/turn signals on the side of my JKU (not just on the grille). And the turns flash in time with my factory bulbs (not interlaced). I tried another 3-wire LED first but couldn't get it to work in both modes (running or spinning, not both) since standard two-filament bulbs switch grounds? I've seen the same…

So here's a quick rundown of the Maxxima LED parking and turn signal/brake lights. I did a little experiment. The gap/marker only version of this light is the two wire M09300Y. This version of the M09300YAT has three wires going into the light; Red black and white. The WHITE wire is ground. The RED wire provides full brightness and the BLACK wire provides reduced brightness. The package reports drawing at 45 mA (bright) and 15 mA (diminished). The black thing in the middle of the cable in the…