Mishimoto MMRAD-350Z-07 Performance Aluminum Radiator for Nissan 350Z 2007-2009: Enhance Cooling Efficiency & Engine Performance Review

I didn't like that it is advertised as a product that fits certain years of vehicle and once you try to install it has to be changed.

waste of time and money buying, did not fit, do not buy. got a refund but had to spend money to install it and it didn't work. The part is not in the correct position as the original.

You cannot line up and screw on the AC condenser and your standard fans will NOT fit. What worries me is that I called Mishimoto to make sure there was no problem installing it and they assured me I wouldn't. This was installed on a 2008 Nissan 350Z (VQ35HR).

I've had it for about a week now and so far so good. In fact, there is a certain confidence that my car cools well. It took me a little time to install it myself, had to bend a bit of metal to line everything up, but eventually everything fit. The quality of the goods I see very good and clean.

Great product after many people said they had trouble setting it up to 350z lie the bad guy had to enlarge the holes on the bottom a bit with a drill but it didn't last longer than 10 minutes and just glue it with the fans already on it and it should take 20 minutes if you need pics message me on insta @sleepyvino

The installation was ALMOST perfect. Everything fit, I had to make some minor adjustments and the fans are a PAIN to come back with that thicker heatsink but I promise it can be done without damage. The top posts where it snaps into main support is the only place I've encountered installation issues, but even then they were minor. I also had to adjust the AC condenser, it has little tabs that can be adjusted if the radiator isn't perfectly aligned to begin with, so don't worry if it moves a bit

Ahhh, shiny new Mishimoto cooler. I'm glad I got another one for another car. Had already installed two on my other vehicles before. However, this one for my 08 350z required the most adjustments. The aluminum tongue of the "legs" holding the radiator from below had to be sanded down on one side, the original place of attachment of the legs is slightly shifted. I used my dremel and shaved about 1/4 inch off one of the legs so it would slide and hold properly. It added about 40 minutes to the…