🍃 Mossy Oak Graphics 14010: Vinyl Skin for Universal Auto Emblems - Unlimited Patterns! Review

To be honest I was skeptical. My husband thought it was a good idea and I thought we'd give it a try due to the low cost. I was impressed with the transformation of my car emblem (Chevy bow tie). It only took a few minutes to cover the old one and it stayed completely intact. I am so happy with this product. Actually I bought another one for the front! Featured!

Shipping was amazing. Super fast. It's a rectangular sticker that was creased in the middle, but that wasn't a problem. I started it from the corner and slowly smoothed out any wrinkles by gluing it to my logo on the front. (First I cleaned the emblem for better adhesion) After applying it with no dents or creases, I pressed through the edges so I could see where the edges of my emblem were, and then took a box cutter and circled them . I pressed down part of the sticker on the left edges to…

I take some blame because when I started to put it on I made a mistake and moved it. Well, it looks more like the Texas flag than the American flag. At least for me. Another thing is that the Chevrolet emblem is 2 1/2 inches wide. The sticker they send is 1/2 shorter so you can only use one logo. For the money I think it should cover both. Anyway, I think I'll film this because I live in Florida, not Texas. Hey Texas, you can't get knocked down. If the company sent another one for free, I would

I have read all the reviews and don't have much sympathy for customers who complain about having to cut them themselves. It seems if you have time to write a review, you will have time to read it as well. Mine arrived unfolded and well packaged. It took a few tries to place it so that it doesn't look like the Texas state flag, didn't it? I wanted as many stars as possible so I tipped mine a bit and it turned out great. I even completely uninstalled and rearranged it once. It's easy to get rid…

Attach this to the front and back of your bow tie. I decided the rear one would be best just above the emblem, but the front one also covered up the prominent chrome bar of the emblem. How I installed it: Cleaned the emblem with rubbing alcohol. I warmed up the logo with a hair dryer. Using the center fold line as a guide and stretching the sticker's label slightly, I attached the sticker. Again, use the hair dryer to gently heat the decal while gently rubbing it in place. Using an exacto…

I've seen reviews on both sides of the fence on this product and have to say my experience falls somewhere in between. Installation could have been a bit easier if they hadn't just folded the decal to wrap it up. The end result is a stunning look and I love how it looks on my truck. The heat gun greatly simplifies installation and eliminates wrinkles. I ripped one up trying to install it, but that was my fault. You just have to be careful and move very slowly and make sure the decal is pressed…

got it yesterday and installed this morning. I'm not sure how long it will last, but it has held up really well. I would recommend watching a YouTube video for instructions. That helped. But I would add that a new razor blade is important. Otherwise, your haircuts can look messy. I don't have a hair dryer so I used my wife's hair dryer. It worked fine. Warning: This decal barely matched the emblem on my 2014 Silverado's grille. I had to rotate it so that the top right corner of the decal…

Vinyl is not precut to match your logo. The picture shows it, but you will receive a 10" x 4" American Flag Mossy Oak vinyl wrap designed exactly like the one in the picture. This is why so many people complain about it and wish it was already pre-cut, but it's actually a lot better than it isn't. Chevy logos/butterflies vary in size for each Chevy you own. So if you get a full sheet, feel free to customize the logo any way you want! BUT. All you need is a fairly sharp knife, preferably a box…