🏍️ Kawasaki Ninja 650R ER-6F 06-16 650 2012-2016 Motorcycle Handlebars Kit - Clip-On Adapter Plate with Separating Handlebars Set, Precision CNC Aluminum Alloy Construction, ER-6F 2006-2016 Review

I love how the bike looks and feels special! Still very comfortable but you get better handling and it locks all the way left and right without touching anything, just like the original on my 2006 Ninja 650r! It also looks very successful! Highly recommended!

As mentioned in another review, clamps do not tighten around bars to the point where the head of one of the bolts breaks off. However, the rods are free to enter the clamps and slide even though the screws are fully tightened. I see this product only has potential if the parts fit/work properly.

They have completely changed the feel of my bike and how easily it rocked from side to side. A more aggressive feel and way better when trying to tank without touring handlebars while still maintaining comfort and control. I wish it was a little lower, but if it were you wouldn't be able to achieve full block like you can with them. You need to find a good balance for the levers so they fit between the dash and windshield without pushing or rubbing too hard. But a great product and appears to…

After receiving the latches, I checked and made sure everything was there. Let's move on to the installation of grilles. Everything lined up smoothly and where they should be except when I was trying to tighten the screws holding the bar in place. I lined everything up and hand tightened the bolts, slowly checking between each turn to see if the rod was holding in place. The bars were still loose so I tightened them a little and the screws snapped. Everything is fine as I don't plan on taking…

This bar is definitely better than the standard bar but no better than the previous secondary bar I had. (I was hoping for a low profile bar like the previous one.) This bar sits high, like the stock bar, but looks a lot better. You can see the gap between the fairing and the brake lever. My previous bars were 3 inches lower which made them comfortable for low corners. I'm considering machining the center bracket for height adjustment. All holes fit. Standard cords will fit, they just need to…

First you will need to purchase the correct size screws from your local hardware store. M6x12mm with a pitch of 1.0 is sufficient for clamps. Replace the odd M6x5mm screws that come pre-installed in the clamps with the o-ring for the supplied 16mm screws. The handlebar kit is designed to replace the stock handlebars on the '08 Ninja 650r. I drilled new holes for the stop piece that keeps the clusters from rotating. I unplugged the clutch sensor for a tighter fit (I can come back to that). The…