NewYall Engine Valve Cover Gasket Replacement Parts Review

***UPDATE*** I HAD TO REMOVE THE VALVE COVER AFTER A FEW DAYS AFTER INSTALLATION AND STARTED USING RTV ON THE ENTIRE GASKET NOT JUST THE CORNERS WHAT IS ALMOST PAPER THIN. Appears to be cheaply made. Not as thick as OEM. The crescent-shaped cutout on the back of the rocker cover gasket is nowhere near OEM, so much so that I thought it would leak, but so far so good. It would be very nice if it was of higher quality but for the price it's not bad but the resolution could be better.

This product did not sit flush on the head as it was approximately 15mm less wide. It was necessary to tighten the gasket at the crankshaft chain tensioner and at certain corner points along the head parallel to the windshield and also along the front of the head parallel to the radiator. Integrated Half-Diameter The area of the Moon rubber seal that fills the gap near the passenger-side end of the crankshaft was not large enough to fill the Half-Moon gap and required the use of a black seal…