🖨️ Creality 4010 Extruder Hot End Fan - 40x40x10MM, 24V DC Original Cooling Fan Turbo Circle for 3D Printer Parts Ender 3/Ender 3 Pro Review

Injector fan GGRRRHRHRHRHR Started 2 weeks after fitment, failed quickly. When I turn I feel an inner resistance - something is broken. Garbage.

I am reinstalling my Ender 5 and would like to use the new hot end fans. They are exactly the same as the originals, even the wiring is the same. The hot-end fan has bare wires and the filament fan has a 2-pin connector. A very affordable price that allowed me to reinstall the hotend without worrying about breaking the original fans.

Fit was the same as the original parts. Installation was easy and intuitive. My original fan had a broken blade causing vibration and uneven pressure, this completely solved the problem.

My extruder fan broke so I had to replace it quickly. I found that on the original Ender 3 Pros fan it was possible to remove the sticker to reveal the fan circuit board, so I had the idea of buying an identical replacement and soldering the new fan directly to avoid cutting the Avoid cables and the use of shrink tubing. However, the fan I received was not the fan shown in the picture and there is no way to access the board without damaging it! So much for that idea :/ Still using it although…

The fans were identical to the original fans that came with the Ender-5 3D printer. However, the wiring and connector on the fan part 4010 (blue and yellow wires) are different from the OEM version. The OEM 24V fan with blue and yellow wires has a black 2-pin connector (20 AWG JST SM 2) and looks like 20 AWG. The replacement fan wiring appears to be 22 AWG with a white 2-pin JST connector. Nothing, connected and working properly. I could probably leave the white JST and connect it to the…

The fans work great but I was hoping to get some with JST connectors already installed. I passed out for a while because I needed the right JST connectors and a crimping tool just to use them and I've never crimped JST connectors which was quite annoying as my hands are big and clumsy. Good fans for Ender 5 Pro if you like the process.

Although the hot end fan was a great replacement, the cooling fan portion was not the same as my Ender 5. The overall size of the fan blade on the fan side was noticeably smaller than in the drain and therefore presses less air. Since I can't rate a 2.5 because only half the fans were correct, I round up to 2 due to the added frustration of having to pick up another fan.

Direct replacement fan in stock. They do NOT come with a Molex connector, but that's fine as they're easier to connect with some solder and heat shrink instead of messing around with the wiring harness and running the wires to the motherboard. Especially if you have an Ender 3 Pro, the only way to access the circuit board is to turn the device upside down.