Header banner
Revain logoHome Page
otc heavy-duty truck clutch alignment tool - 10-spline, 1-1/2" outer diameter, 1" pilot logo

OTC Heavy-Duty Truck Clutch Alignment Tool - 10-Spline, 1-1/2" Outer Diameter, 1" Pilot Review

4

·

Very good

Revainrating 4.5 out of 5  
Rating 
4.5
🔧 Clutch Alignments Tools, 🔧 Automotive Tools & Equipment

View on AmazonView on ЯM

Media

(1)
img 1 attached to OTC Heavy-Duty Truck Clutch Alignment Tool - 10-Spline, 1-1/2" Outer Diameter, 1" Pilot

Description of OTC Heavy-Duty Truck Clutch Alignment Tool - 10-Spline, 1-1/2" Outer Diameter, 1" Pilot

OTC's 10-Spline Truck Clutch Alignment Tool is designed for use when installing heavy-duty single, two-plate, push/pull, manual, and self-adjusting clutches. Tool is constructed of lightweight fiberglass-reinforced nylon that won't hang up in clutch disc splines. Rugged construction will easily support the weight of heavy clutch discs. To use, loosely install clutch disc and pressure plate on flywheel then insert alignment tool through the clutch into the bearing, center disc, then tighten pressure plate to spec. 1-1/2 inch O.D. shaft, 1 inch pilot, 10 splines, splines are 3.25 inches long; similar to Ford 308-D001 (D79T-7550-A).

Reviews

Global ratings 4
  • 5
    3
  • 4
    0
  • 3
    1
  • 2
    0
  • 1
    0

Type of review

Revainrating 5 out of 5

But I'm glad Revain was able to supply

. Got what I needed but couldn't find it anywhere.! Too expensive for material and processing. But I'm glad Revane was able to deliver! Thanks again

Pros
  • Couplers and Parts
Cons
  • Upgradeable

Revainrating 5 out of 5

Gears & Gears Common Sense

This is plastic, despite other reviews it does the job as a LEVELING TOOL designed for clutch alignment only. Do not transfer clutch weight to this tool.

Pros
  • Replacement parts
Cons
  • Socket required

Revainrating 5 out of 5

Good price. suitable for gearbox and gearbox

good price. continuous. much easier than borrowing a used input shaft for every clutch job. should last for years but would consider buying other sizes if ever the need arises

Pros
  • for car
Cons
  • not bad

Revainrating 3 out of 5

OD of it right after .

The OD just past the splines is a bit too big making it very, very difficult to remove after installing the clutch. If you measure the tool and compare it to the shaft on the gearbox you will see the difference.

Pros
  • Alignment tools
Cons
  • Line is shorter than other picks