Header banner
Revain logoHome Page
๐Ÿ’Ž pc products pc clear two part 70161: the ultimate solution for crystal clear coating on your pc components logo

๐Ÿ’Ž PC Products PC Clear Two Part 70161: The Ultimate Solution for Crystal Clear Coating on Your PC Components Review

3

ยท

Poor

Revainrating 2.5 out of 5ย ย 
Ratingย 
2.3
๐Ÿ”ง Epoxy Adhesives, ๐Ÿ”’ Tapes, Adhesives & Sealants

View on AmazonView on ะฏM

Media

(2)
img 1 attached to ๐Ÿ’Ž PC Products PC Clear Two Part 70161: The Ultimate Solution for Crystal Clear Coating on Your PC Components
img 2 attached to ๐Ÿ’Ž PC Products PC Clear Two Part 70161: The Ultimate Solution for Crystal Clear Coating on Your PC Components

Description of ๐Ÿ’Ž PC Products PC Clear Two Part 70161: The Ultimate Solution for Crystal Clear Coating on Your PC Components

Clear epoxy adhesive liquid bonds wood, metal, glass, ceramic, concrete, and fabric. When mixed it turns opaque initially then clear to full cure to blend in with bonded material. Continuous service temperature range from -20 to +200 degrees F. Provides work time of approximately 4 minutes, cure time for function of 1 hour, and full cure time of 24 hours. Forms tough bond for durability.

Reviews

Global ratings 3
  • 5
    0
  • 4
    0
  • 3
    2
  • 2
    0
  • 1
    1

Type of review

Revainrating 1 out of 5

Excellent control and performance as intended

Works as intended. Like the fact that you have separate containers to control the release of the glue better than piston type epoxies.

Pros
  • Clear liquid epoxy bonds wood, metal, glass, ceramic, concrete and fabric
Cons
  • Large and bulky

Revainrating 3 out of 5

Adhesives, sealants and lubricants too thick to pour

already too thick to pour and forget to level. It solidifies in the form of a drop when poured. It says "4 minutes" but the actual run time is closer to 8 seconds. I can see it's great for a sinking ship, but no more!

Pros
  • Working time approx 4 minutes, cure time to function 1 hour and full cure time 24 hours
Cons
  • Requires base

Revainrating 3 out of 5

Not for gluing thin parts.

I love PC PRODUCTS. That was a little disappointing; it did not fit on a glued stone slab. It may have been my fault, but even with the "technical attachment", the clamp and the 24 hour drying time, it was a failure. I think it's still a very good epoxy; just need enough surface to hold.

Pros
  • Continuous operating temperature range -20 to +200 degrees Fahrenheit
Cons
  • Can't remember