Rannb 🔧 Carpenter Router Cutter Diameter Review

For $10, that's hard to fault. I needed a rounded indent and this worked for me. I may never need it again, but for one time use it was worth the money. Edit: Turns out I was able to find a lot of uses for it, but after maybe 10 cuts it definitely gets boring. . And since I expect more from it, I'll probably shell out a higher quality racket.

I bought this to make wooden eggshells. I wanted to make a pair as a gift for friends who have chicken coops. It worked well for the first two 1" holes he drilled. Then it was done. The shavings were gone by the next 4 my husband drilled. A complete waste of money. We used it with a drill press which should be even better than using a drill press. But you can get the same results with a drill as well. Very disappointing. I would return but the return period was two days ago.

The bit has 2 grooves. One looked normal, the other was obviously defective. Instead of a flat piece of carbide that was sharpened to the cutting edge, the carbide was curved, resulting in the center of the cutting edge. In fact, it was made weak. How could it pass any reasonable quality check? So basically I got a single edge cutter with a counterweight on the other side. Since I was milling plastic, I got by with this, but there was a lot of chatter when cutting. I think you get what you pay…