🔑 High-Quality Key Fob Cover for Honda 2003-2012 Accord, 2006-2013 Civic EX, 2009-2015 Pilot, 2005-2006 CR-V, Ridgeline, Odyssey - Compatible Replacement Buttons Review

The fit isn't perfect, there's a little gap at the end but the screw keeps it in place so I don't mind too much. But it looks great.

The screw hole never matched so the two sides never closed completely. Now it's broken and I'm going to get a new one. I think you get what you pay for.

My key broke off the remote and is unusable. It was so easy to use and now I can use my key again. That doesn't bring Pete any closer, but it's not an obstacle for me.

Works very well, excellent quality. Be careful to insert the key sleeve into the key fob and do not push in, otherwise it will not seat properly. I had to fiddle with it a bit before realizing that it fits better than new. 5 Stars

It's a bit difficult to assemble, you can't just snap everything together and force it. You must insert the key holder into one half of the case before snapping the two halves together. Watch the video if you are confused. Once put together the quality is great and feels sturdier than the factory.

It was a little difficult to install, it required some cutting force with a screwdriver. Well that was for my husband who unfortunately has very strong hands but the original key case (from the dealer) has lasted the last few years while this lasted a week before suffering the same damage as the original key case. But for key and chip it's perfect. But be warned, there are single-sided clips that need to be snapped in first, and it helps to snap the key part on one side before you snap them…

In general, I am very happy with the case. I purchased this item to replace the original key fobs on my 2006 Honda Ridgeline. Installing the original electronics, immobilizer RFID chip and key is easy. The plastic seems to be of good quality and I like that there is a Honda logo on the back. I gave it four stars because of two small flaws. First, the immobilizer chip just hangs in the key fob since there is no "housing" for it in the design. To be honest it's not that much. I made a small pad…