🔧 Mavic 2 Pro Zoom Drone Repair Parts: Left Front Leg Foot Accessory - Replacement Landing Gear Review

This is a great chassis that is easy to install. They even include the key you need for installation. It is robust and almost OEM. The only downside is that it's a bit thicker than the OEM so the chassis extensions won't fit it.

If you need a replacement boarding pole, that's fine. It's cheap and easy to install. I have a quality problem. Third-party parts usually differ slightly in design, but that's pretty far off. The screw holes match, but that's about it. The leg does not fit flush with the rest of the propeller, and there is a noticeable overlap where it connects to the rest of the block. Replacement screws are not included. The color doesn't match the drone either - it's a bit lighter.

For almost 2 years the only way to get this part was to buy a whole arm of the Mavic Pro/Zoom 2. They made them for the original Mavic Pro but not for version 2. Well, finally someone made them. Someone in China, no doubt, but whatever. I bought a pair, installed the right foot and all went well. The quality is good and it is very close to the original OEM leg. TIP. Search YouTube for videos on how to tighten the Mavic 2's leg without removing the arm. It turns a 2-hour installation nightmare…

These chassis are poorly made. A large amount of plastic scrap during the molding process prevents them from assembling and reinstalling the screws properly. I had to spend quite a bit of time with a razor blade and a drill to fix the problem a bit, but one of the screw holes had blisters from excess plastic and I had to use a soldering iron and sandpaper to smooth it out. The color is also a bit different as mentioned in other comments, but it's not that noticeable. The main problem is that…