Replacement Shop Vac Floor Brush Review

Works better than the floor nozzle that comes with the vacuum. I wish I had bought this LONG EARLY. When it comes to cleaning cement floors, this thing works really well. I would buy again if needed. It's holding up very well, so I don't think I'll need another for a few years.

Works great for sweeping forward, not pulling back. I think because of the little brush underneath. The wheels are good. I had to tape it to the end of my vacuum hose because it was too big and fell off every few minutes. There aren't many options for replacement tips, so you might as well buy one.

I've been looking for something like this for a long time! It works great for cleaning dirt on cement floors. It takes a little getting used to as you have to press it, but you'll be thankful you have it. It also has enough suction power throughout to suck everything up. Makes cleaning my workshop so much easier!

Good value for money but more of a specialty nozzle than a general purpose suction nozzle. The brush is fairly short with little to no bend. So when you pull the nozzle toward you, it tends to "plow" dirt and dust onto the edge of the brush on the opposite side of the suction side. It's good for loosening small sawdust or plaster dust, but only for collecting. The brush is also thick enough to stop airflow, so dust doesn't build up in the brush and the brush head snags on the floor when tilted…

Obviously designed for a marine vacuum but not very good for the job. It has small, tiny wheels that won't roll on rough, dirty surfaces where you use a shop vacuum. It also doesn't have much of the brush surface you need to sweep debris into the nozzle. I think the only application where this works well is in a lumber shop where there are few custom or large, heavy items. It wasn't very efficient to clean the concrete floor to lay the laminate, which was littered with bits of drywall, carpet…

Searched for this in hardware stores and hardware stores everywhere (formerly carried by Home Depot). The wheels allow the head to easily move across the floor and clear debris. Everything else was a struggle. The lack of bristles on the nozzle meant the floor was sucked up with no movement, the bristles around the nozzle just pushed small particles of dust and dirt. In my opinion, this is the ONLY way to vacuum and clean a concrete floor! Please never drop this product.

This attachment was purchased for use with the My Shop Vac. I like the fact that the hole has a small gap at the bottom. It sucks much better than my vacuum cleaner. It's great for cleaning concrete floors as it picks up sand and dirt much better than the Shop Vac. The only complaint about the material the nozzle is made of. The plastic is very hard and smooth, unlike the material used in the wand of a vacuum cleaner. When cleaning, the nozzle often slips off the end of the extension tube. That

This attachment was ordered to replace the one that came with my Sears commercial vacuum. It is about twice as wide as the original, so it sucks much faster. I mainly use it in the garage and collects sawdust and other small debris well. The opening is fairly narrow so it won't accommodate items larger than 1/4 inch, but that's not a problem for me. If you regularly pick up large debris, you may need a different attachment. The brush on the back of the nozzle does a good job of sweeping, but…