🔪 Roman Carbide Straight DC1830 (Set of 3) Review

They come in a beautiful rosewood box and work just as well as anything I've found. Sometimes I have a hard time reading grain and lose my temper, but no more so with these than with other more expensive products. I chose a spiral nozzle, but it's expensive. So if you want value for money and all in a neat little box for storage these bits are for you.

I bought this set with a 1/2" Freud top bearing bit. I only have the bottom bearing and one of the upper bearing jets used. , a couple of times each. Freud's stance is a bit loose. Roman's sight was tightened perfectly. There is a small blister on the paint on one of the bits. That's the only downside I see. Other than that, they do their job very well good.As good as Freud and the few Boschs I have.The wood finish is as nice and smooth as any other piece I've tried.So far this seems like a…

I'm not happy with this set. The edges are ok, they worked for what I was doing but I didn't use them for anything precise. However, I do have a complaint that one of the roll pins holding the bearing in place fell out when I was using the smaller top mount bit. I did template routing and it ended up messing up my template before I noticed the problem. I had to create a completely new template. I do not recommend.