RV Designer Collection E365 Cover Plate Review

Will not fit my 1998 Coleman Natchez pop up van. This exhaust cap has a single screw hole. I had 3 holes but thought one would be fine. Opened the shaft and found that the 2 outer screws actually hold the exit to the camper. Centrally attaches it to an outlet, but it can be inflated widely in the wind and is not attached to the camper.

Bought a new camper van but the outside socket that came with it was in an awkward spot for me so I used this as a cover for one other outlet I installed where I wanted. I look the same as the ones I already had on the RV, but the springs on this one hold the caps tighter and help keep the exhaust port clean. It comes with all the necessary screws and gaskets for a professional, clean installation.

I bought this cover for my 2005 Alpenlite fifth wheel. The new cap is an exact replacement for the original, even by part number and patent number. The new foam padding supplied is slightly larger and therefore even denser than the original. I argued for a long time between this cover and a slightly more expensive one, but in the end I settled on this one. Like the lie that "size matters," "more expensive" doesn't necessarily mean better. Like them you will not be disappointed!

This socket cover works like the original on my popup as the original cover had faded This is for use on an external socket, it will fit without modification. Simply pull off the old one and screw it on, done. The instructions state that using sealant will help prevent water from entering the outlet which could create a potential hazard before the RCD trips. This looks great on my popup and is way better than the previous one. If you have an outlet that looks a little dirty or broken, this will