🔩 Pack of 20 Small Clear Round Rubber Feet - .250 Height x .671 Diameter - 100% Made in USA - Food-Safe for Cutting Boards, Electronics, and Crafts Review

I bought these for a chopping board but they are hard rubber/plastic and don't stick well to the countertop. They might be good for some uses, but not for a cutting board in my opinion!

Looks good. Ease of installation. Not enough friction. I give it a 5 out of 10 for cushioning with 10 being the best. I use them for my feet so nothing slips. It's harder than most rubber feet so doesn't hold up well, but that's okay.

I bought these to put on the underside of an end grain cutting board I made for my wife. I wanted the board to have feet so it would stay in place and raised off the counter to keep it dry. I chose them because I figured the clear coat wouldn't leave marks on the countertop.

Used them on the underside of my cutting board to allow air circulation and prevent the board from warping. Pre-drilled holes and attached ½" pan head stainless steel screws. Adhesive pads always fall off. They stay and have a higher profile.

They fit my knife block perfectly, but they are quite hard plastic, definitely not "rubber" -- minus one star for inaccurate description. I used Parts Express #6 x 3/4" deep pan head screws, black, qty. 100. (1), they match these legs and bite into the end wood well without chipping, with a pre-drilled hole.

Disappointed that they don't come with screws. Luckily, Hubs is a jack of all trades with a well-stocked shop, so he probably has something to get them up and running. But for many people I see where it would be difficult and uncomfortable. If you order something online, it has to be ready. If I wanted to go to a store, I wouldn't buy online.

I should have known more before buying. These are not non-slip rubbers and are practically useless for me on cutting boards. However, this does not prevent the planks from sliding on the granite countertop as they are very hard "plastic" rubber feet to the touch. We'll keep them and use them for something else, but I don't recommend them for cutting boards if you're looking for a non-slip solution.