🔒 Sovol 3D Cleaning Touchscreen Protector: Enhanced Protection for Your Device! Review

This is a nice addition to my polymer print production cycle. I use a smaller pre-rinse glass for a quick first soval pre-soval to prevent a large amount of alcohol from clouding too quickly. Soval then does his thing before I throw the impression into my ultrasonic bath. I can say that Soval is doing a good job as the liquid in the ultrasonic device stays clean much longer than before.

Cleaning my prints made a great impression. Just walk in, press the time button (if needed) and press start. My prints come out very clean. I switched from using only water washable resin to regular resin. Only 2 minor problems. I wish there was a countdown timer so you know how much time is left and I wish it could be used with water based cleaners but as it has a bearing which can rust it is not recommended. These are the little things that are available at all wash bays. I also like the fact

The build quality is actually quite good. The design is simple but durable. There are electronics. OK. The touchpad on the front can be a bit finicky at times and will sometimes register a keypress when it wasn't there, but works fine 99% of the time. My first device had a problem where it got stuck in the middle. Cycle as if the stop button was pressed every other wash, but the replacement doesn't seem to have this problem. I've used two machines for my 2 step resin process and they work well…